Introduction to Source-Connect 3.9 Pro and QManager: Auto-Restore and Replace

This article is part of the Source-Connect Pro and Pro X 3.9 User Guide

This section provides a complete overview on using Source-Connect from version 3.2 and up with Restore and Replace. Q Manager version 2 provides easier and faster Restore and Replace operations, plus several additional back-up options.

This section is divided into 12 parts: 

1. Ultra-QuickStart Guide
2. Lifecycle of a recording
3. Launch and Configure the Q Manager for recording
4. Login mode
5. FTP settings
6. Using Auto-Restore and Auto-Replace: Details
7. What is Auto-Restore and Auto-Replace?
8. Comprehensive Q Manager interface overview
9. Invalid Q Manager settings and warnings
10. Q Activity panel
11. Troubleshooting
12. Common Q Manager issues

This section starts with a step-by-step guide to using Auto-Restore and Auto-Replace. It is important that you understand what settings need to be verified. This is briefly covered in section 8.1: Ultra-QuickStart Guide, so please review section 8 .3. Launch and Configure the Q Manager for recording if your recording needs are outside of the scope of the QuickStart guide. 

The online Q Manager Help guide is also available directly from on the Q Manager setup panel and will take you to the comprehensive Q Manager guide online. You can refer to this guide whenever needed for quick help. 

If you have any questions on working with the Q Manager and Auto-Restore and AutoReplace please contact Support.