Ultra-QuickStart Guide for Source-Connect 3.9 Pro

This article is part of the Source-Connect Pro and Pro X 3.9 User Guide

This section is provided for the most common case uses. 

1. Launch Source-Connect Pro and connect using 44.1khz or 48khz, with bitrate of 64kbps mono or higher. 
2. The Q manager will login automatically. Check that your FTP service is active. If you get an FTP error see the FTP error section of this manual or contact Support. 
3. Set your audio files folder / session folder in the Q Manager Setup panel. This is the folder where you will record your actual files to. 
4. Make sure you have Restore and Replace checked in the Source-Connect settings panel.
5. Connect with Source-Connect to your connection partner and check that you have a Q icon on the Receive status, next to the blinking Receive light. 
6. Record a test file – it should show up immediately in your Q Requests. If it says Restored, select and choose Replace Now from options menu. 

If it progresses and comes back saying Replaced, you’re good to go!