Introduction to Source-Connect 3.9 Pro and QManager: Auto-Restore and Replace
This article is part of the Source-Connect Pro and Pro X 3.9 User Guide
This section provides a complete overview on using Source-Connect from version 3.2 and up with Restore and Replace. Q Manager version 2 provides easier and faster Restore and Replace operations, plus several additional back-up options.
This section is divided into 12 parts:
- Ultra-QuickStart Guide
- Lifecycle of a recording
- Launch and Configure the Q Manager for recording
- Login mode
- FTP settings
- Using Auto-Restore and Auto-Replace: Details
- What is Auto-Restore and Auto-Replace?
- Comprehensive Q Manager interface overview
- Invalid Q Manager settings and warnings
- Q Activity panel
- Common Q Manager issues
This section starts with a step-by-step guide to using Auto-Restore and Auto-Replace. It is important that you understand what settings need to be verified. This is briefly covered in section 8.1: Ultra-QuickStart Guide, so please review section 8 .3. Launch and Configure the Q Manager for recording if your recording needs are outside of the scope of the QuickStart guide.
The online Q Manager Help guide is also available directly from on the Q Manager setup panel and will take you to the comprehensive Q Manager guide online. You can refer to this guide whenever needed for quick help.
If you have any questions on working with the Q Manager and Auto-Restore and AutoReplace please contact Support.